Custom Pewter Kitchen Cabinet Knobs

I have finally finished my kitchen. It was a long slog of sanding and painting but I am very happy with the result.

hand painted painted kitchen

The worst bit was re-aataching the cupboard doors after they had been painted. Suffice to say that I never want to see another kitchen cabinet hinge again! Whilst witnessing my sighs and mutterings (as I tried to get all the doors straight by adjusting one of three mysterious screws in each hinge) my husband helpfully suggested we ‘get a man in’. He is, of course a man himself, but although he has many talents, adjusting kitchen cabinet hinges isn’t one of them! I had got this far without ‘getting a man in’ and I wasn’t about to give up at the last hurdle.

farrow and ball painted kitchen

The cabinets were refinished in Farrow & Ball’s Bone – a lovely restful colour that is neither grey nor green.

I created some custom pewter knobs for the cupboard doors – each with a tiny pen & ink drawing, in the style of a victorian engraving, of animals, curios and household bits and pieces.

custom kitchen door knobs

Here are the whole set – all 21 of them!

bespoke pewter door pulspewter kitchen door knobcustom door pulls

If you are interested in finding out more about how I made them… read on!

pewter cupboard knob

I started with some customisable pewter knobs from The Crafty Store on Etsy. They have a flat recessed face that will accept a 25mm circular paper insert. This was covered with a glass cabochons (25mm domed discs of glass) which fit over the top of the paper insert to protect, and magnify, it.

mod podge

I also needed a 25mm circular punch, some of the wonderfully named Mod Podge (to seal the drawings) and Diamond Glaze (to glue it all together)

I drew the little pictures onto circles cut from wallpaper samples using my Rotring technical pens.

wallpaper samples

Here are some of them (I didnt use the letters in the end)!

pen and ink drawings

Each paper disc then had to be sealed with several coats of Mod Podge to prevent the colours from running or reacting with the metal. The inside of the pewter knobs were also sealed as sometimes the metal can cause discolouration. I then glued each paper disc to the flat side of the glass cabochon using a drop of Diamond Glaze. When it was dry the glass cabochon with the paper disc attached was glued into the pewter knob.

I had a lot of fun experimenting with different inserts…

custom cabinet knob ideas

I love some of the simple graphics – numbers and letters and the maps… but for my kitchen project I stuck with the pen & ink drawings as they complimented the look I was after.

set of custom pewter knobs

Time consuming but lots of fun!

So it is done at last and the tools are back where they belong – in the garage!

Now back to some printmaking!

Advertisements